Turnkey installation
Air-to-water heat pump installation
A heat pump heats, cools and warms the water for the whole home. Here is how the installation goes step by step, from the site visit to commissioning.
- Site visit
- Installation
- Commissioning

How the installation goes
From the site visit to a warm home
- 01
The site visit
We come over, measure, assess the insulation, the windows and any existing system, and calculate the heat loss. That gives the heat pump's power and the place for every part.
- 02
The outdoor unit
We set the outdoor unit on a stand above snow level, with free space in front and at the sides and a condensate drain, away from bedrooms and neighbours because of the noise.
- 03
Connecting the house
Insulated pipes through the wall connect the outdoor unit to the house. In split systems these are refrigerant lines to the indoor module, laid by certified technicians.
- 04
The hydraulics
In the utility room we install the hydraulic module with a circulation pump, expansion vessel and safety group, and a buffer tank when the system needs one.
- 05
Hot water
A three-way valve switches the heat pump between the heating and the hot water cylinder, which heats from the bottom up through its coil.
- 06
The heating
Underfloor heating and radiators receive water at a low temperature, where the heat pump is most economical. If existing radiators are small, we tell you which to replace.
- 07
Commissioning
We fill and bleed the system, check the pressure, set the heating curve and the hot water schedule, and show you how to control everything from the unit and your phone.
What the installation includes
- A site visit and a heat-loss calculation
- Choosing the power and where each part goes
- Mounting the outdoor unit on a stand with a condensate drain
- Pipe connections between the outdoor unit and the house
- Hydraulic module, pump, expansion vessel and safety group
- Connecting a hot water cylinder and buffer tank where present
- Filling, bleeding, setting up and commissioning
- An explanation of how to control the system
We settle the exact scope at the site visit.
What we need from you
- Access to the spot for the outdoor unit and to the utility room
- A power supply to the unit's requirements (we check at the site visit)
- Information about any existing system
The products
Units we install
Before you decide
Questions about the installation
How long does the installation take?
It depends on the scope: replacing a boiler with a heat pump in a house with a working system usually takes a few days, while a new system with underfloor heating is done with the renovation. We give the exact time after the site visit.
Can a heat pump work with my existing radiators?
Usually yes. At the site visit we check whether the radiators give enough heat at the lower water temperature, and where one is too small we suggest a larger one.
Is a heat pump noisy?
The indoor part is quiet. The outdoor unit can be heard up close, so we place it away from bedrooms and neighbours and mount it on anti-vibration feet.
Request
Request a site visit
Describe your home and we will get in touch to arrange a site visit and a quote.


